Critical Link Ground Distribution

Nickel earth distribution

0/4 and 8 AWG cable input – 4/8 AWG cable output

2 way

• Full Range 6.5" 4-Way Speaker Pair
• 400 Watts MAX 200 Watts RMS Power Handling per Pair
• 65 Hz to 22 kHz Frequency Response and 85dB Sensitivity
• Polypropylene Woofer Cone and Rubber Surround
• 2 Tweeters and 1.25 inch Mylar Cone Midrange Per Speaker
• Sold in Pairs

• Component 6.5" 2-Way Speaker Pair
• 500 Watts MAX 250 Watts RMS Power Handling per Pair
• 65 Hz to 20 kHz Frequency Response and 94dB Sensitivity
• Electroplate Injection Woofer Cone and Rubber Surround
• 1 Tweeter Per Speaker
• Sold in Pairs

• One 12" Woofer with DUAL 4 ohm Voice Coil
• 2600 Watts MAX 1300 Watts RMS Power Handling
• 88dB Sensitivity, 28 Hz Resonant Frequency
• Polypropylene & Paper Cone and Rubber Surround
• Works in .65 CuFt Sealed or 1.5 CuFt Ported enclosure

• One 10" Woofer with DUAL 4 ohm Voice Coil
• 2100 Watts MAX 1050 Watts RMS Power Handling
• 88dB Sensitivity, 34 Hz Resonant Frequency
• Poly Injection Cone and Rubber Surround
• Works in .65 CuFt Sealed or 1 CuFt Ported enclosure

• Space Saver - The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options. Embrace the Bass.
• Built-in Amplifier - A built-in 800 Max watt amplifier powers the subwoofer
• Pulse Width Modulated - This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable
• Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
• High Level Input - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
• Low Level Input - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BAB8 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
• Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.

Amplified Space Saver

A built-in amplifier powers the 8-inch subwoofer. No need to have a subwoofer housed in a box AND a separate amplifier. If you have a small cabin to work with, the BAB8 will provide the rich bass that every sound system cannot do without.

Remote Subwoofer Control

A wired remote subwoofer control at your fingertips gives you control, so when the need hits… so does your BASS