BOSS Audio Systems BAB8 Amplified Car Subwoofer – 800 Watts Max Power, Low Profile, 8 Inch Subwoofer, Remote Subwoofer Control, Great for Vehicles That Need Bass But Have Limited Space
Space Saver – The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options. Embrace the Bass.
Built-in Amplifier – A built-in 800 Max watt amplifier powers the subwoofer
Pulse Width Modulated – This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable
Variable Low-Pass Filter – A low-pass filter is an electronic circuit that removes all the notes below the filter’s frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
High Level Input – Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
Low Level Input – Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BAB8 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
Variable Bass Boost – Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
Break Your Subwoofer In
Much like the engine of a new automobile, a new subwoofer must go through a short but important process of “break-in” before it is run under harsh conditions. The “break-in” process will ensure the subwoofer is able to perform as it has been designed to. This process involves subjecting the subwoofer to no more than low-to-medium volume levels for a number of hours in the enclosure. 3-4 hours is generally sufficient for the subwoofer’s suspension to loosen enough to prevent the voice coil(s) from overheating and causing failure. The break-in period is also effective in extending subwoofer life. Over-driving the woofer before it has been properly broken-in will usually result in premature failure and poor performance.
8-inch 800-Watt subwoofer
Class A/B built-in amplifier
MOSFET power supply
RCA & speaker level input
Phase control
Bass boost
Low pass filter
Remote subwoofer control
Amplified Space Saver
A built-in amplifier powers the 8-inch subwoofer. No need to have a subwoofer housed in a box AND a separate amplifier. If you have a small cabin to work with, the BAB8 will provide the rich bass that every sound system cannot do without.
Remote Subwoofer Control
A wired remote subwoofer control at your fingertips gives you control, so when the need hits… so does your BASS
Reviews
There are no reviews yet.
Be the first to review “BOSS Audio Systems BAB8 Amplified Car Subwoofer” Cancel reply
BOSS Audio Systems BAB8 Amplified Car Subwoofer - 800 Watts Max Power, Low Profile, 8 Inch Subwoofer, Remote Subwoofer Control, Great for Vehicles That Need Bass But Have Limited Space
Chaos Exxtreme 6" x 9" 2-Way 350W Full Range Speakers. (Sold in Pairs)
Boss Audio System Phantom - 12" DUAL Voice Coil (4 Ohm) 2600W Subwoofer. (Sold Single) P129DC
BlackDeath 6 Inch Pro Audio Midrange
High Output 6″ Pro Audio
Driver Alloy Gasket included
Sold in Singles
BOSS Audio Systems BVCP9700A-C Apple CarPlay Android Auto Car Multimedia Player - 7 Inch Capacitive Touchscreen, Bluetooth, No CD DVD, Multi-Color Illumination, Backup Camera Included
The PULSE12 is part of the series of affordable subwoofers that deliver all of the brand values synonymous with VIBE.
Content
BOSS Audio Systems BAB8 Amplified Car Subwoofer
Space Saver - The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options. Embrace the Bass.
Built-in Amplifier - A built-in 800 Max watt amplifier powers the subwoofer
Pulse Width Modulated - This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
High Level Input - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
Low Level Input - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the BAB8 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
Break Your Subwoofer In
Much like the engine of a new automobile, a new subwoofer must go through a short but important process of “break-in” before it is run under harsh conditions. The “break-in” process will ensure the subwoofer is able to perform as it has been designed to. This process involves subjecting the subwoofer to no more than low-to-medium volume levels for a number of hours in the enclosure. 3-4 hours is generally sufficient for the subwoofer’s suspension to loosen enough to prevent the voice coil(s) from overheating and causing failure. The break-in period is also effective in extending subwoofer life. Over-driving the woofer before it has been properly broken-in will usually result in premature failure and poor performance.
8-inch 800-Watt subwoofer
Class A/B built-in amplifier
MOSFET power supply
RCA & speaker level input
Phase control
Bass boost
Low pass filter
Remote subwoofer control
Amplified Space Saver
A built-in amplifier powers the 8-inch subwoofer. No need to have a subwoofer housed in a box AND a separate amplifier. If you have a small cabin to work with, the BAB8 will provide the rich bass that every sound system cannot do without.
Remote Subwoofer Control
A wired remote subwoofer control at your fingertips gives you control, so when the need hits… so does your BASS
Full Range 6" x 9" 2-Way Speaker Pair
350 Watts MAX 175 Watts RMS Power Handling per Pair
50 Hz to 20 kHz Frequency Response and 92dB Sensitivity
Poly Injection Woofer Cone and Rubber Surround
1 Tweeter Per Speaker
Sold in Pairs
One 12" Woofer with DUAL 4 ohm Voice Coil
2600 Watts MAX 1300 Watts RMS Power Handling
88dB Sensitivity, 28 Hz Resonant Frequency
Polypropylene & Paper Cone and Rubber Surround
Works in .65 CuFt Sealed or 1.5 CuFt Ported enclosure
Competition 6" pro audio speaker
The BDPRO6M-V9: BlackDeath 6 Inch Pro Audio Midrange component woofer is designed with excellent mid-bass response in mind. Semi-pressed paper cone has high sensitivity and low moving mass for monstrous output Dual roll cloth surround offers fast, precise dampening of the cone with great bass response. The BlackHole Dustcap increases effective cone area for higher SPL creating extreme volume.
Blackdeath range
VIBE Audio’s BlackDeath range is all about taking things to the extreme and creating products so crazy they have no right to exist. BlackDeath isn’t just about pushing the boundaries of audio innovation, it’s about annihilating them.
For many years people have been asking for coaxial and component speakers that are worthy to wear the BlackDeath logo, and after extensive development Vibe are proud to release the BlackDeath Pro Audio range. Derived from PA speaker design, BlackDeath Pro Audio speakers are capable of immense sound pressure levels, meaning volume like you’ve never heard before. Ideal for competition use or for those who just want to play their music loud and proud.
Specifications
Model : BlackDeath Pro 6M
Configuration : 1 Way
Speaker Size : 6″ (170mm)
RMS Power : 175 watts
Peak Power : 525 watts
Minimum Input : 75 watts
Sensitivity : 97 dB
Freq. Response : 75 Hz – 10 kHz
Impedance : 4 Ohm
Mounting Depth : 2.7″ (68mm)
Mounting Diameter: 5.7″ (146mm)
Voice Coil Diameter : 2″ (38mm)
Magnet Weight : 34 oz
Torsion basket featuring snap on mounting tabs for greater installation flexibility.
Sold as single speaker
Apple CarPlay - Access icons on your iPhone by activating Siri voice controls the touchscreen. Available features include Phone, Music, Maps, Text messages, Radio, Podcasts, Audiobooks
Messages - With Siri on your side, you can ask her to read you your messages, reply as well as send them. Siri lets you concentrate on what matters most. Driving
Maps - Need gas? Hungry? Search along your route by asking Siri, and CarPlay will direct you every step of the way and tell you the speed limit too. Third-party navigation apps like Google Maps, Waze and Baidu are also available
Bluetooth - Make calls hands-free with the help of Siri. Play music apps like Spotify or Pandora as well as iTunes and Apple Music Subscription. Siri will be your DJ
Android Auto - Just say “Ok Google” and Google Assistant will help throughout your day. Get real-time alerts on Google Maps and Waze. Make calls, check your messages, reply back, use music apps, all while keeping your hands on the steering wheel
APPS: Rearrange how you want your apps to appear in CarPlay through the settings on your iPhone. Supported apps include WhatsApp, Radio Disney, Amazon, iHeartRadio, Podcasts, Google Play Music, CBS Radio and more
Inputs - USB, USB charging, SD, AV, rear & front camera. The steering wheel interface allows you to use the existing functions on your steering wheel. Interface module sold separately. We recommend the Metra ASWC-1
PULSE12-V0 - 12 Inch Subwoofer
Low budget doesn’t have to mean low performance! The PULSE12 is part of the series of affordable subwoofers that deliver all of the brand values synonymous with VIBE.
The same wide roll foam surround technology found in our SLICK series subwoofers allows huge excursion and delivery of powerful bass, this paired with our custom tooled duscap for added rigidity and harmonised engineering or voice coil, spider, cone and magnet allows deep low frequencies and accurate bass reproduction.
High temperature single 4Ω voice coils deliver maximum flexibility with a wide range of amplifiers including bridged onto any of our multi-channel Powerbox amplifiers.
Reviews
There are no reviews yet.